What is a perimeter drain, and where may a BC house send its water?
For new work the BC Building Code drains a house's footings, unless shown unnecessary, to a sewer, a ditch or a dry well, by sump pump where gravity won't; the council sets its own rules.
Opens the lot's report at this answer. If an address isn't found, try the PID, the 9-digit parcel number on the land title or assessment notice.
What the answer means
A perimeter drain, also called a foundation drain, footing drain or weeping tile, is a perforated pipe around the outside of the footings that carries groundwater away from the basement or crawl space. For work it covers, the BC Building Code says where that water may go: a sewer, a drainage ditch or a dry well, pumped up from a sump where it can't run there by gravity. In town the council's bylaws say which sewer, whether replacing a drain needs a permit, and where the owner's pipe ends.
- What the Code asks
- Unless it can be shown to be unnecessary, the bottom of every exterior foundation wall is drained, either by drain tile or pipe laid around the outside of the foundation or by a layer of gravel or crushed rock under and beyond the footings (BC Building Code 2024, Division B, Sentence 9.14.2.1 (1); Article 9.14.4.2).
- The pipe
- Drain tile or pipe is at least 100 mm across, laid on undisturbed or compacted soil with its top below the basement slab or the crawl space's ground cover, and covered on top and sides by at least 150 mm of crushed stone or other coarse, clean granular material (9.14.3.2, 9.14.3.3 (1), (4)). Clay and concrete tile are still on the Code's list of materials, as is plastic pipe (9.14.3.1); an older house most often has clay or concrete tile with open joints, which roots and silt can block over the years (our reading).
- Where the water goes
- Foundation drains drain to a sewer, a drainage ditch or a dry well (9.14.5.1). A dry well is allowed only where the natural groundwater sits below its bottom, at least 5 m from the foundation and placed so the water drains away from the building (9.14.5.3).
- Sumps and sump pumps
- A sump pit is at least 750 mm deep and 0.25 m² in area, with a cover children can't remove that is also airtight (9.14.5.2 (1), (2)). Where gravity drainage isn't practical, an automatic sump pump lifts the water from the pit to a sewer, a drainage ditch or a dry well (9.14.5.2 (3)). A pump needs power, so it stops in an outage unless something backs it up (our reading; see backup generators).
- Roof water and the ground around the house
- The building is placed or the site graded so water doesn't collect at or near it, and surface water is sent away from a water supply well or a septic field (9.14.6.1, 9.14.6.2). Downspouts not connected to a sewer get extensions that carry the rain away from the building without washing out the soil (9.26.18.2). The City of Port Alberni's guide asks for the solid roof leader pipes to be kept separate from the perforated perimeter drain.
- In town: the permit and the storm sewer
- Each council sets its own rules in its building and sewer bylaws. The City of Port Alberni, as one example, asks for a perimeter drain permit to replace all or part of one under its building bylaw, says perimeter drains must connect to the storm sewer, allows no connection to its services at the property line without its Public Works Department's approval, and has the drainage inspected before it's backfilled; plumbing beyond small repairs needs a separate plumbing permit. Ask yours before the digger comes, and call BC One Call first (see call before you dig).
- Whose pipe it is
- The pipe from the house to the street is most often the owner's to keep. The District of Oak Bay, for one, makes owners responsible for the work and cost of their storm and sewer laterals from the house to where they meet the public main past the property line, suggests a camera inspection every 1 to 3 years, and replaces the part between the property line and the main itself at the rates in its bylaw. Where your council draws the line is in its sewer bylaw (see backwater valves).
- Not into the sanitary sewer
- Councils keep groundwater and rain out of the sanitary sewer, which is why Port Alberni sends perimeter drains to the storm sewer. An older house whose foundation drain or sump pump empties into the sanitary sewer or a floor drain is worth raising with the inspector and the council (our reading).
- On a rural lot
- With no storm sewer, a house's drains go to a ditch or a dry well (9.14.5.1). Water sent onto a neighbour's land, into a stream or into a ditch along a provincial road is another set of rules (see drainage), and a drain or sump emptying into a septic field loads it with water it wasn't sized for (our reading; see septic).
- What it means for a buyer
- Damp or white mineral marks low on the basement walls, or a sump pump that runs often, are the usual signs an inspector notes. A camera down the drain from its cleanouts shows whether the old tile is broken or blocked, and the council's property file shows whether a replacement had a permit (see official records on a property). Ask your insurer what it covers for water coming through the foundation or backing up from a drain (see flood insurance).
Our summary of the BC Building Code 2024 (Division B, Section 9.14 and Article 9.26.18.2), the City of Port Alberni's Homeowners Guide to Perimeter Drain Installation/Repairs and its perimeter drain permit application (2023), and the District of Oak Bay's storm and sewer laterals page, read 2026-10-23. Each council's building and sewer bylaws set their own permits and connection rules: ask yours.
Sources (read 2026-10-23; summarised in our own words unless noted): British Columbia Building Code 2024 (Division B, Section 9.14, Article 9.26.18.2), Province of BC; Homeowners Guide to Perimeter Drain Installation/Repairs, City of Port Alberni; Perimeter Drain Permit Application (2023), City of Port Alberni; Storm and Sewer Laterals, District of Oak Bay.
Before you buy: who to ask
- The seller or their agent
- Has the perimeter drain been replaced or repaired, when and under what permit? Has the basement or crawl space ever taken water, and does a sump pump run?
- Your home inspector or a specialist
- Where are the cleanouts, and should a plumber run a camera down the perimeter drain and the storm lateral? Do the downspouts and any sump pump go to the storm sewer, the sanitary sewer or the ground?
- The local government
- Does replacing a perimeter drain need a permit here, where may it connect, and where does the owner's part of the storm connection end?
Look up the lot above: its report shows the floodplain maps, water within 30 m and, on a rural lot, the septic screening.
See also backwater valves, drainage, home inspections, mould and moisture, flood and sewer backup cover, call before you dig and foundation repair.