Does replacing a furnace need a permit in BC?
A gas or propane furnace needs a Technical Safety BC gas permit, or for natural gas the city's in the few that issue their own, and some councils, Kamloops among them, add a permit.
Opens the lot's report at this answer. If an address isn't found, try the PID, the 9-digit parcel number on the land title or assessment notice.
What the answer means
Installing or replacing a gas furnace needs a gas permit from Technical Safety BC, or from the city in the few that issue their own natural gas permits. The council's building bylaw can add its own: Kamloops needs a permit to install or modify a heating system, ductless ones included. An oil furnace, a wood stove and a heat pump each bring rules of their own.
- Gas and propane
- Technical Safety BC says a gas permit is needed for installing or replacing all gas appliances such as a furnace, water heater, fireplace or boiler, and for installing or replacing gas piping or vent systems (its homeowner gas permits page). An owner may do the work under a homeowner permit only in a fully detached home they live in, where no one is paid to help and no part is rented (Gas Safety Regulation ss. 1, 4, 24, as the electrical and gas permits page reads them); otherwise a licensed gas contractor takes the permit.
- Whose gas permit
- Technical Safety BC issues gas permits across BC except where a city issues its own: Burnaby, Maple Ridge, the City and District of North Vancouver, Vancouver, Kelowna and Richmond for natural gas at the meter's low pressure. Those cities' gas permits cover natural gas only, so propane work goes to Technical Safety BC (as the electrical and gas permits page reads Technical Safety BC's jurisdiction page; see propane tanks).
- The council's side
- The City of Kamloops needs a permit to install or modify a heating system, ductless systems included, and to install a gas fireplace as a heating appliance; it leaves work under Technical Safety BC's jurisdiction, such as electrical or gas, to Technical Safety BC's own permits, but says that work may also need a City plumbing permit when a furnace is changed from low to high efficiency or relocated (its Bulletin No. 23-01, When Building Permits Are Required, revised April 2025). The District of Central Saanich sends natural gas and electrical permits to Technical Safety BC and fireplace and wood-burning appliance permits to its fire department (its residential building permit guide, revised October 2019). Other councils differ: ask the building department (our reading).
- Electric heat
- An electric furnace or baseboard heaters are wired on their own circuits, so the wiring is electrical work under the Electrical Safety Regulation and its permits (as the electrical and gas permits page reads it). Whether like-for-like replacement needs a permit isn't plain from the regulation's list of work needing none, so ask Technical Safety BC (our reading).
- Oil, wood or a heat pump
- An oil furnace often sits on a buried or basement oil tank, which carries its own fire code and cleanup questions (see old heating oil tanks). A wood stove or wood furnace has its own install and yearly inspection rules (see wood stoves and chimney inspection). Switching to a heat pump brings an electrical permit and refrigerant work by an approved person (see heat pumps).
- Carbon monoxide alarms
- New work that adds a fuel-burning appliance brings the Building Code's carbon monoxide alarms near the bedrooms (Division B 9.32.4.2, as the smoke and CO alarms page reads it).
- Asbestos in old heating
- WorkSafeBC says asbestos was widely used in BC building materials until the early 1990s and that you can't tell by looking (as the asbestos page reads it). Before work begins on renovating a building, every employer responsible for the work, and the owner, must have a qualified person inspect it for hazardous materials (Occupational Health and Safety Regulation s. 20.112), so hired work on an older furnace, its ducts or a boiler's pipes is work the survey reaches (our reading).
- Owned or rented
- Some furnaces are rented or financed, not owned. A deal that secures payment for goods fixed to the house can be filed as a notice on the land title, and the company can remove the goods on notice if it isn't paid (Personal Property Security Act ss. 36, 49, as the rented and financed equipment page reads them). The contract should say whether it stays, and who takes over the rental (our reading).
- Rebates
- Rebates for heating upgrades, where offered, are listed by CleanBC Better Homes; check its current list before you count on one (see EnerGuide evaluations).
- What it means for a buyer
- Ask how old the furnace is, who installed it, and for its service record. A gas furnace should have a Technical Safety BC permit, which its Permit Lookup Tool shows by address, open or closed (as the electrical and gas permits page reads it). A missing permit is unpermitted work the next owner inherits (see unpermitted work).
Our summary of Technical Safety BC's homeowner gas permits page, the City of Kamloops' Bulletin No. 23-01 (revised April 2025) and the District of Central Saanich's residential building permit guide (revised October 2019), read 2026-10-28, and of the Gas and Electrical Safety Regulations, the Building Code's CO alarm article, the hazardous materials survey and the Personal Property Security Act as their own pages read them. Other councils' building bylaws differ and we haven't read them: ask the council.
Source: Homeowner gas permits, Technical Safety BC (summarised in our words, read 2026-10-28); Bulletin No. 23-01, When Building Permits Are Required, City of Kamloops (revised April 2025; summarised in our words, read 2026-10-28); Residential building permit guide, District of Central Saanich (revised October 2019; summarised in our words, read 2026-10-28); Gas Safety Regulation, B.C. Reg. 103/2004, ss. 1, 4, 23, 24 (summarised in our words, read 2026-10-19); Find rebates, CleanBC Better Homes (linked, read 2026-10-28).
Before you buy: who to ask
- The seller or their agent
- How old is the furnace, what does it burn, who installed it, and under which permits? Is it owned, rented or financed? Is there an oil tank, in use or not? Is there a service record?
- The local government
- Does your bylaw need a permit to replace or change the heating system? Do you issue your own gas or electrical permits?
Look up the lot above: its climate section gives the heating degree days the furnace has to cover.
See also heat pumps, electrical and gas permits, old heating oil tanks, replacing a water heater, smoke and CO alarms and rented and financed equipment.