PlaceDossier / Questions

Do I need a permit to add insulation to a house in BC?

It depends on the council: Kamloops needs a permit to take drywall off exterior walls, while an attic top-up isn't on its lists either way; old vermiculite stays undisturbed.

Opens the lot's report at this answer. If an address isn't found, try the PID, the 9-digit parcel number on the land title or assessment notice.

Share

TextEmail

Text and Email open your messages or email app with this message, ready to edit.

What the answer means

No provincial rule says whether adding insulation needs a building permit: each council's or regional district's building bylaw does. Of the councils we read, Kamloops needs a permit to remove drywall on exterior walls or fire separations and asks for a hazardous materials assessment before it permits renovating a home older than 1992; topping up an attic is on neither its permit list nor its no-permit list, so ask. Insulating a wall from inside most often means taking that drywall off (our reading). Natural Resources Canada's retrofit guide says to check with the municipal office about permits before starting, and that where no permit is issued, whoever does the work must make sure it meets the building codes.

Who decides
Whether work needs a building permit is set by the local building bylaw, so the answer is the council's, or the regional district's where it runs building inspection (our reading; see building permits for which electoral areas have it). Natural Resources Canada's guide says to check with your municipal office and building inspector, and the utility where applicable, for requirements and permits before beginning a retrofit (Keeping the Heat In, 2017).
Kamloops
The City of Kamloops lists the removal of drywall on fire separations or exterior walls among the interior renovations that will require a permit, and says a hazardous assessment will be required before it issues a building permit for any renovation or addition to a home older than 1992. Its lists of work needing a permit and work needing none don't name adding insulation in an attic, so whether that needs one there is unclear (its Bulletin No. 23-01, When Building Permits Are Required, revised April 2025).
Where no permit is needed
Where a building permit isn't required or issued, so no inspector checks the work, Natural Resources Canada says whoever is doing the work must make sure the work and materials meet the relevant building codes and standards (Keeping the Heat In, 2017).
Fire
Natural Resources Canada warns never to let insulation touch a chimney or combustion vent, an exposed recessed light fixture or old knob-and-tube wiring, as these can be a fire hazard (Keeping the Heat In, 2017). Knob-and-tube wiring is set out on old wiring and plumbing, and moving or replacing wiring is electrical work under a Technical Safety BC permit (see electrical and gas permits).
Air sealing and moisture
The guide says more insulation means a colder attic, where moist indoor air can condense before it is vented, so the attic should be air sealed first. As a general rule, it says, attic ventilation should be present and not blocked with insulation, wet insulation shouldn't be covered until the source of moisture is gone and it is dry, insulation damaged by mould or vermin should come out, and a house should have a vapour barrier on the warm side of the insulation (Keeping the Heat In, 2017); it's advice, not a code rule (our reading). See mould and moisture.
Vermiculite
Natural Resources Canada says not to disturb vermiculite insulation, and that to be safe, if a home has older vermiculite insulation it should be assumed that it may contain some asbestos (Keeping the Heat In, 2017). What to do about it is set out on vermiculite insulation; urea formaldehyde foam on UFFI insulation.
Before work starts
Before work begins on renovating a building, every employer responsible for the work, and the owner, must have a qualified person inspect it for hazardous materials (Occupational Health and Safety Regulation s. 20.112), so hired work opening walls or an attic in an older house is work the survey reaches (our reading; see asbestos).
An energy evaluation and rebates
An EnerGuide home evaluation before the work, with a blower door test, shows where the house loses the most heat, and some rebate programs ask for one before and after (see EnerGuide evaluations). Rebates for insulation are listed by CleanBC Better Homes, linked below; we don't say what any program pays, as amounts change.
In a strata
In a strata, opening exterior walls touches what the strata corporation insures and usually common property, so it needs the strata's written approval under the Standard Bylaws unless its filed bylaws say otherwise (as the strata renovations page reads them).
What it means for a buyer
Ask the seller what was insulated, when, by whom and whether a permit was taken; an attic with frost, staining or wet insulation, or vermiculite, is worth a home inspector's look before subjects come off (our reading; see home inspections).

Our summary of the City of Kamloops' Bulletin No. 23-01 (revised April 2025) and Natural Resources Canada's Keeping the Heat In (2017 edition), read 2026-10-28, and of the hazardous materials survey, vermiculite and strata rules as their own pages read them. Other councils' building bylaws differ and we haven't read them: ask the council.

Source: Bulletin No. 23-01, When Building Permits Are Required, City of Kamloops (revised April 2025; summarised in our words, read 2026-10-28); Keeping the Heat In, Natural Resources Canada (2017 edition; summarised in our words, read 2026-10-28); Occupational Health and Safety Regulation, Part 20 (s. 20.112), WorkSafeBC (summarised in our words, read 2026-10-19); Find rebates, CleanBC Better Homes (linked, read 2026-10-28).

Before you buy: who to ask

The seller or their agent
What was insulated, when and by whom, and was a permit taken? Is there vermiculite in the attic or walls, or old wiring under the insulation? Was an EnerGuide evaluation done?
The local government
Does your building bylaw need a permit for the insulation work I plan, in the attic or the walls?
Your home inspector or a specialist
What insulation is in the attic and walls, is any of it wet, mouldy or vermiculite, and is the attic ventilated?

Look up the lot above: its climate section gives the heating degree days the insulation has to cover.

See also vermiculite insulation, UFFI insulation, EnerGuide evaluations, heat pumps, old wiring, mould and moisture, finishing an attic and renovating a strata unit.