PlaceDossier / BC places / Aquifers

BC aquifer 954 · bedrock · 1.5 km² · Sunshine Coast

Aquifer 954: Sakinaw Lake near Steep Spring

Aquifer 954 (Sakinaw Lake near Steep Spring) is a fractured crystalline bedrock aquifer of 1.5 km² in the Sunshine Coast Regional District, mapped in 2012. The province rates its productivity low, its vulnerability to contamination from the surface high, and the demand on it low. 6 wells on record are linked to it; water-supply wells there are typically 83.8 m deep and tested at a median 3.8 L/min. It lies under Sunshine Coast, Electoral Area A.

How the province rates it

Productivity low, vulnerability high, demand low.

RatingWhat it means
Productivity
how much water the aquifer gives up to wells, judged from well yields, the aquifer material and pumping tests
lowWater comes slowly: the guide's low band is silt, fine sand or fractured bedrock, or typical well yields under about 0.3 L/s (18 L/min). A well may still supply a house, but it isn't assured.
Vulnerability
how easily something spilled at the ground surface could reach the water, judged from what lies above the aquifer and how deep the water is
high (class A)Little natural protection (the guide's class A): a shallow water table or sand and gravel above it lets surface water and spills soak down quickly.
Demand
how much the aquifer is used now, judged from the number and density of wells and what they're used for
lowLightly used: about 4 or fewer domestic wells per km² where homes rely on private wells.
Level of development Inferred
demand compared with productivity
Moderate (class II)Read by us from the guide's table of demand against productivity; where it gives two classes the mapper chose with local knowledge. Heavy (I): new wells should be carefully assessed; moderate (II): given careful thought; light (III): more use is usually fine if the aquifer can supply it.

Ratings are the province's, set when the aquifer was mapped (2012) from wells, geology and local studies. Vulnerability is about the ground, not what's built on it: a well-protected aquifer under a busy area can still be at more risk than an exposed one in the bush.

Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.

The wells in it

6 wells on record are linked to this aquifer.

Wells linked6 (1 water-supply)
Water-supply well depthmedian 83.8 m; middle half 83.8 m to 83.8 m (1 well)
Tested yieldmedian 3.8 L/min; middle half 3.8 L/min to 3.8 L/min (1 well tested)
Drilled1999

Depths are how deep the driller finished the well; yields are the driller's test, often an hour or less, in litres per minute. A domestic well's yield is usually judged against the household's peak use; ask a driller what's enough for yours.

Where it is

N 0500 m

Outline simplified by us from the provincial map; not for locating a lot.

KindFractured crystalline bedrock
Geological unitBedrock; fractured granite
Location, as describedSakinaw Lake near Steep Spring
Area1.5 km²
Water useHousehold wells
Water quality concernsNone documented
Mapped2012

Bedrock: water moves through cracks in the rock, so two wells close together can find very different amounts. The province's page for this aquifer lists the studies behind it and its observation wells: GWELLS aquifer 954.

Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.

What this record doesn't cover

The province maps aquifers where wells and studies give enough to go on, mostly in settled valleys; most of BC isn't mapped, and a lot outside every outline can still have groundwater. Outlines are drawn from geology and well logs at the scale of the study, so an edge can be well off on the ground, and one aquifer can lie under another. Wells are linked to an aquifer by provincial staff from the driller's log: not every well inside an outline is linked, and well depths and yields are as the driller reported them, often from a short test.

These are mapped ratings and drillers' records, not a test of any one lot. Before you buy a property on a well, or plan to drill, ask a qualified hydrogeologist or a registered well driller what this aquifer gives where you are, and test the water.