PlaceDossier / BC places / Aquifers
Aquifer 8: Sardis-Vedder
Aquifer 8 (Sardis-Vedder) is an unconfined sand and gravel (alluvial or colluvial fan) aquifer of 58 km² in the Fraser Valley Regional District, mapped in 2019. The province rates its vulnerability to contamination from the surface high; its productivity and demand are not rated. 141 wells on record are linked to it; water-supply wells there are typically 18.6 m deep and tested at a median 227 L/min. It lies under Chilliwack.
BC aquifer 8 · sand and gravel · 58 km² · Fraser Valley
How the province rates it
Productivity not rated, vulnerability high, demand not rated.
| Rating | What it means | |
|---|---|---|
| Productivity how much water the aquifer gives up to wells, judged from well yields, the aquifer material and pumping tests | not rated | The province hasn't rated this for this aquifer. |
| Vulnerability how easily something spilled at the ground surface could reach the water, judged from what lies above the aquifer and how deep the water is | high (class A) | Little natural protection (class A in the Province's aquifer classification guide): a shallow water table or sand and gravel above it lets surface water and spills soak down quickly. |
| Demand how much the aquifer is used now, judged from the number and density of wells and what they're used for | not rated | The province hasn't rated this for this aquifer. |
| Level of development Inferred demand compared with productivity | unclear | Unclear: the province hasn't rated both demand and productivity. |
Ratings are the province's, set when the aquifer was mapped (2019) from wells, geology and local studies. Vulnerability is about the ground, not what's built on it: a well-protected aquifer under a busy area can still be at more risk than an exposed one in the bush.
Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.
The wells in it
141 wells on record are linked to this aquifer.
| Wells linked | 141 (88 water-supply) |
|---|---|
| Water-supply well depth | median 18.6 m; middle half 13.2 m to 25.8 m (86 wells) |
| Tested yield | median 227 L/min; middle half 75.7 L/min to 946 L/min (53 wells tested) |
| Water level below ground | median 3.4 m when drilled (60 wells) |
| Flowing (artesian) wells | 2: water rose to or above the ground when drilled |
| Drilled | 1901 to 2023 |
This aquifer's medianIts middle half of wellsAnother BC aquifer's median
Depths are how deep the driller finished the well; yields are the driller's test, often an hour or less, in litres per minute. A domestic well's yield is usually judged against the household's peak use; ask a driller what's enough for yours.
Is the water level falling?
1 provincial observation well still measured here.
| Observation well 406 | water level falling about 7.1 cm a year (moderate rate) over 2014 to 2023; falling about 3.3 cm a year (moderate rate) over 2010 to 2023; water typically 3 m below ground in a well 19 m deep |
|---|
Observation wells are the Province's monitoring wells, their water level measured for years or decades. The trend is the Province's reading of one well's yearly levels: a decline of 3 to 10 cm a year that the record clearly shows is a moderate rate, 10 cm or more a large one, anything not clear is stable or no clear trend. It shows how the aquifer has behaved there, not what a well on this lot will give; confirm with a qualified hydrogeologist or registered well driller.
Source: Long-term Trends in Groundwater Levels in B.C., Environmental Reporting BC (Provincial Groundwater Observation Well Network), records to December 2023 (Open Government Licence – British Columbia). Wording by PlaceDossier.
What the water tested for
The median manganese was over Health Canada's limit at 1 of 5 wells sampled here.
6 wells in this aquifer were sampled for the Province's records from 2003 to 2019, 2 of them the Province's observation wells (406, 459).
| Typical well (median) | Highest sample | Samples over the limit | Wells | |
|---|---|---|---|---|
| Arsenic limit 0.010 mg/L | 0.000113 mg/L | 0.0012 mg/L | none of 48 samples | 5 |
| Fluoride limit 1.5 mg/L | 0.035 mg/L | 0.05 mg/L | none of 46 samples | 5 |
| Manganese limit 0.12 mg/L; 0.02 mg/L for taste and staining | 0.00302 mg/L | 0.334 mg/L | 2 of 48 samples, at 2 wells 10 over the taste and staining level | 5 |
| Uranium limit 0.02 mg/L | 0.000017 mg/L | 0.000187 mg/L | none of 48 samples | 5 |
| Nitrate (as nitrogen) limit 10 mg/L | 0.066 mg/L | 1.71 mg/L | none of 44 samples | 6 |
| Lead limit 0.005 mg/L | 0.00005 mg/L | 0.000613 mg/L | none of 48 samples | 5 |
These are samples of raw water, before any treatment, from wells in the Province's environmental monitoring records since 2000: its observation wells and groundwater surveys, water systems' wells and other drinking-water wells; wells at landfills, mines and permit holders' works are left out. A result below the lab's detection limit counts at that limit. Lead mostly comes from a well's pipes and fittings rather than the aquifer. Groundwater changes over short distances and with depth, so a nearby well says what the aquifer can hold, not what a well on this lot gives. Bacteria aren't shown: they depend on how each well is built and kept. Health Canada's Guidelines for Canadian Drinking Water Quality set the most a drinking water should hold: arsenic 0.010 mg/L, fluoride 1.5 mg/L, manganese 0.12 mg/L (and 0.02 mg/L for taste and for staining laundry and fixtures), uranium 0.02 mg/L, nitrate 10 mg/L as nitrogen (45 mg/L as nitrate) and lead 0.005 mg/L, with arsenic and lead kept as low as reasonably achievable. Our summary of Health Canada's summary table, read 2026-10-11.
Test your own well, for bacteria and these, at an accredited lab; your health authority can say which labs take samples from private wells. Health authority contacts.
Source: Environmental Monitoring Data System (EnMoDS) results, Province of BC (Open Government Licence – British Columbia); Health Canada's guidelines. Wells are those the Province links to this aquifer; a well with no link counts here when this is the only mapped aquifer under it. Wording by PlaceDossier.
Where it is
| Kind | Unconfined sand and gravel - alluvial or colluvial fan |
|---|---|
| Geological unit | Holocene alluvial fan |
| Location, as described | Vedder Alluvial Fan, Vedder Crossing |
| Area | 58 km² |
| Mapped | 2019 |
Unconfined: nothing tight lies over it, so rain and surface water soak straight down to it; the water table rises and falls with the seasons. The province's page for this aquifer lists the studies behind it and its observation wells: GWELLS aquifer 8.
Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.
What this record doesn't cover
The province maps aquifers where wells and studies give enough to go on, mostly in settled valleys; most of BC isn't mapped, and a lot outside every outline can still have groundwater. Outlines are drawn from geology and well logs at the scale of the study, so an edge can be well off on the ground, and one aquifer can lie under another. Wells are linked to an aquifer by provincial staff from the driller's log: not every well inside an outline is linked, and well depths and yields are as the driller reported them, often from a short test.
These are mapped ratings and drillers' records, not a test of any one lot. Before you buy a property on a well, or plan to drill, ask a qualified hydrogeologist or a registered well driller what this aquifer gives where you are, and test the water.