PlaceDossier / BC places / Aquifers
Aquifer 709: Gabriola; excluding northern portion
Aquifer 709 (Gabriola; excluding northern portion) is a fractured sedimentary rock aquifer of 47 km² in the Nanaimo Regional District, mapped in 2004. The province rates its productivity low, its vulnerability to contamination from the surface high, and the demand on it moderate. 1,047 wells on record are linked to it; water-supply wells there are typically 32 m deep and tested at a median 15.1 L/min. It lies under Nanaimo, Electoral Area B.
BC aquifer 709 · bedrock · 47 km² · Nanaimo
How the province rates it
Productivity low, vulnerability high, demand moderate.
| Rating | What it means | |
|---|---|---|
| Productivity how much water the aquifer gives up to wells, judged from well yields, the aquifer material and pumping tests | low | Water comes slowly. The low band in the Province's aquifer classification guide is silt, fine sand or fractured bedrock, or typical well yields under about 0.3 L/s (18 L/min). A well may still supply a house, but it isn't assured. |
| Vulnerability how easily something spilled at the ground surface could reach the water, judged from what lies above the aquifer and how deep the water is | high (class A) | Little natural protection (class A in the Province's aquifer classification guide): a shallow water table or sand and gravel above it lets surface water and spills soak down quickly. |
| Demand how much the aquifer is used now, judged from the number and density of wells and what they're used for | moderate | Moderately used: about 4 to 20 domestic wells per km² where homes rely on private wells. |
| Level of development Inferred demand compared with productivity | Heavy or moderate (class I or II) | Read by us from the guide's table of demand against productivity; where it gives two classes the mapper chose with local knowledge. Heavy (I): new wells should be carefully assessed; moderate (II): given careful thought; light (III): more use is usually fine if the aquifer can supply it. |
Ratings are the province's, set when the aquifer was mapped (2004) from wells, geology and local studies. Vulnerability is about the ground, not what's built on it: a well-protected aquifer under a busy area can still be at more risk than an exposed one in the bush.
Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.
The wells in it
1,047 wells on record are linked to this aquifer.
| Wells linked | 1,047 (229 water-supply) |
|---|---|
| Water-supply well depth | median 32 m; middle half 21.3 m to 53.3 m (229 wells) |
| Tested yield | median 15.1 L/min; middle half 7.6 L/min to 37.9 L/min (223 wells tested) |
| Water level below ground | median 6.1 m when drilled (188 wells) |
| Flowing (artesian) wells | 7: water rose to or above the ground when drilled |
| Drilled | 1950 to 2011 |
This aquifer's medianIts middle half of wellsAnother BC aquifer's median
Depths are how deep the driller finished the well; yields are the driller's test, often an hour or less, in litres per minute. A domestic well's yield is usually judged against the household's peak use; ask a driller what's enough for yours.
Is the water level falling?
4 provincial observation wells still measured here.
| Observation well 196 | water level stable or no clear trend over 2014 to 2023; water typically 4 m below ground in a well 99 m deep |
|---|---|
| Observation well 197 | water level stable or no clear trend over 2014 to 2023; water typically 9 m below ground in a well 84 m deep |
| Observation well 316 | water level stable or no clear trend over 2014 to 2023, as over the whole record since 2000; water typically 2 m below ground in a well 13 m deep |
| Observation well 385 | water level stable or no clear trend over 2014 to 2023, as over the whole record since 2010; water typically 14 m below ground in a well 43 m deep |
| Observation well 194 | no trend: no longer measured; water typically 20 m below ground in a well 76 m deep (records 1973 to 2007) |
| Observation well 317 | no trend: no longer measured; water typically 2 m below ground in a well 21 m deep (records 1995 to 2006) |
Observation wells are the Province's monitoring wells, their water level measured for years or decades. The trend is the Province's reading of one well's yearly levels: a decline of 3 to 10 cm a year that the record clearly shows is a moderate rate, 10 cm or more a large one, anything not clear is stable or no clear trend. It shows how the aquifer has behaved there, not what a well on this lot will give; confirm with a qualified hydrogeologist or registered well driller.
Source: Long-term Trends in Groundwater Levels in B.C., Environmental Reporting BC (Provincial Groundwater Observation Well Network), records to December 2023 (Open Government Licence – British Columbia). Wording by PlaceDossier.
What the water tested for
The median manganese was over Health Canada's limit at 3 of 6 wells sampled here.
6 wells in this aquifer were sampled for the Province's records from 2000 to 2017, 6 of them the Province's observation wells (194, 196, 197, 316, 317, 385).
| Typical well (median) | Highest sample | Samples over the limit | Wells | |
|---|---|---|---|---|
| Arsenic limit 0.010 mg/L | 0.000845 mg/L | 0.0058 mg/L | none of 17 samples | 6 |
| Fluoride limit 1.5 mg/L | 0.513 mg/L | 1.23 mg/L | none of 16 samples | 6 |
| Manganese limit 0.12 mg/L; 0.02 mg/L for taste and staining | 0.078 mg/L | 0.357 mg/L | 6 of 18 samples, at 3 wells 9 over the taste and staining level | 6 |
| Uranium limit 0.02 mg/L | 0.0000275 mg/L | 0.00026 mg/L | none of 16 samples | 6 |
| Nitrate (as nitrogen) limit 10 mg/L | 0.007 mg/L | 0.196 mg/L | none of 16 samples | 6 |
| Lead limit 0.005 mg/L | 0.000295 mg/L | 0.00383 mg/L | none of 16 samples | 6 |
These are samples of raw water, before any treatment, from wells in the Province's environmental monitoring records since 2000: its observation wells and groundwater surveys, water systems' wells and other drinking-water wells; wells at landfills, mines and permit holders' works are left out. A result below the lab's detection limit counts at that limit. Lead mostly comes from a well's pipes and fittings rather than the aquifer. Groundwater changes over short distances and with depth, so a nearby well says what the aquifer can hold, not what a well on this lot gives. Bacteria aren't shown: they depend on how each well is built and kept. Health Canada's Guidelines for Canadian Drinking Water Quality set the most a drinking water should hold: arsenic 0.010 mg/L, fluoride 1.5 mg/L, manganese 0.12 mg/L (and 0.02 mg/L for taste and for staining laundry and fixtures), uranium 0.02 mg/L, nitrate 10 mg/L as nitrogen (45 mg/L as nitrate) and lead 0.005 mg/L, with arsenic and lead kept as low as reasonably achievable. Our summary of Health Canada's summary table, read 2026-10-11.
Test your own well, for bacteria and these, at an accredited lab; your health authority can say which labs take samples from private wells. Health authority contacts.
Source: Environmental Monitoring Data System (EnMoDS) results, Province of BC (Open Government Licence – British Columbia); Health Canada's guidelines. Wells are those the Province links to this aquifer; a well with no link counts here when this is the only mapped aquifer under it. Wording by PlaceDossier.
Where it is
| Kind | Fractured sedimentary rock |
|---|---|
| Location, as described | Gabriola; excluding northern portion |
| Area | 47 km² |
| Water use | Household wells |
| Water quality concerns | Local: concerns documented across part of the aquifer |
| Mapped | 2004 |
Bedrock: water moves through cracks in the rock, so two wells close together can find very different amounts. The province's page for this aquifer lists the studies behind it and its observation wells: GWELLS aquifer 709.
Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.
What this record doesn't cover
The province maps aquifers where wells and studies give enough to go on, mostly in settled valleys; most of BC isn't mapped, and a lot outside every outline can still have groundwater. Outlines are drawn from geology and well logs at the scale of the study, so an edge can be well off on the ground, and one aquifer can lie under another. Wells are linked to an aquifer by provincial staff from the driller's log: not every well inside an outline is linked, and well depths and yields are as the driller reported them, often from a short test.
These are mapped ratings and drillers' records, not a test of any one lot. Before you buy a property on a well, or plan to drill, ask a qualified hydrogeologist or a registered well driller what this aquifer gives where you are, and test the water.