PlaceDossier / BC places / Aquifers
Aquifer 68: Belcarra
Aquifer 68 (Belcarra) is a fractured crystalline bedrock aquifer of 1.8 km² in the Metro Vancouver Regional District, mapped in 2007. The province rates its productivity low, its vulnerability to contamination from the surface high, and the demand on it high. 144 wells on record are linked to it; water-supply wells there are typically 85.3 m deep and tested at a median 11.4 L/min. It lies under Belcarra (85%), Port Moody (15%).
BC aquifer 68 · bedrock · 1.8 km² · Metro Vancouver
How the province rates it
Productivity low, vulnerability high, demand high.
| Rating | What it means | |
|---|---|---|
| Productivity how much water the aquifer gives up to wells, judged from well yields, the aquifer material and pumping tests | low | Water comes slowly. The low band in the Province's aquifer classification guide is silt, fine sand or fractured bedrock, or typical well yields under about 0.3 L/s (18 L/min). A well may still supply a house, but it isn't assured. |
| Vulnerability how easily something spilled at the ground surface could reach the water, judged from what lies above the aquifer and how deep the water is | high (class A) | Little natural protection (class A in the Province's aquifer classification guide): a shallow water table or sand and gravel above it lets surface water and spills soak down quickly. |
| Demand how much the aquifer is used now, judged from the number and density of wells and what they're used for | high | Heavily used: where homes rely on private wells, the heavy band in the Province's aquifer classification guide is over 20 domestic wells per km². |
| Level of development Inferred demand compared with productivity | Heavy (class I) | Read by us from the guide's table of demand against productivity; where it gives two classes the mapper chose with local knowledge. Heavy (I): new wells should be carefully assessed; moderate (II): given careful thought; light (III): more use is usually fine if the aquifer can supply it. |
Ratings are the province's, set when the aquifer was mapped (2007) from wells, geology and local studies. Vulnerability is about the ground, not what's built on it: a well-protected aquifer under a busy area can still be at more risk than an exposed one in the bush.
Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.
The wells in it
144 wells on record are linked to this aquifer.
| Wells linked | 144 (71 water-supply) |
|---|---|
| Water-supply well depth | median 85.3 m; middle half 67.1 m to 112 m (67 wells) |
| Tested yield | median 11.4 L/min; middle half 5.7 L/min to 28.4 L/min (55 wells tested) |
| Water level below ground | median 15.2 m when drilled (44 wells) |
| Drilled | 1901 to 2018 |
This aquifer's medianIts middle half of wellsAnother BC aquifer's median
Depths are how deep the driller finished the well; yields are the driller's test, often an hour or less, in litres per minute. A domestic well's yield is usually judged against the household's peak use; ask a driller what's enough for yours.
Is the water level falling?
The Province measured water levels here at 1 observation well, no longer measured.
| Observation well 349 | no trend: too many gaps to judge; water typically 3 m below ground in a well 82 m deep (records 2001 to 2023) |
|---|
Observation wells are the Province's monitoring wells, their water level measured for years or decades. The trend is the Province's reading of one well's yearly levels: a decline of 3 to 10 cm a year that the record clearly shows is a moderate rate, 10 cm or more a large one, anything not clear is stable or no clear trend. It shows how the aquifer has behaved there, not what a well on this lot will give; confirm with a qualified hydrogeologist or registered well driller.
Source: Long-term Trends in Groundwater Levels in B.C., Environmental Reporting BC (Provincial Groundwater Observation Well Network), records to December 2023 (Open Government Licence – British Columbia). Wording by PlaceDossier.
What the water tested for
No well sampled here had a median over Health Canada's limits.
8 wells in this aquifer were sampled for the Province's records from 2003 to 2016, one of them the Province's observation well 349.
| Typical well (median) | Highest sample | Samples over the limit | Wells | |
|---|---|---|---|---|
| Arsenic limit 0.010 mg/L | 0.00085 mg/L | 0.00504 mg/L | none of 81 samples | 8 |
| Fluoride limit 1.5 mg/L | 0.04 mg/L | 0.09 mg/L | none of 73 samples | 8 |
| Manganese limit 0.12 mg/L; 0.02 mg/L for taste and staining | 0.00074 mg/L | 0.0695 mg/L | none of 81 samples 7 over the taste and staining level | 8 |
| Uranium limit 0.02 mg/L | 0.000994 mg/L | 0.00819 mg/L | none of 81 samples | 8 |
| Nitrate (as nitrogen) limit 10 mg/L | 0.156 mg/L | 2 mg/L | none of 53 samples | 8 |
| Lead limit 0.005 mg/L | 0.000268 mg/L | 0.005 mg/L | none of 81 samples | 8 |
These are samples of raw water, before any treatment, from wells in the Province's environmental monitoring records since 2000: its observation wells and groundwater surveys, water systems' wells and other drinking-water wells; wells at landfills, mines and permit holders' works are left out. A result below the lab's detection limit counts at that limit. Lead mostly comes from a well's pipes and fittings rather than the aquifer. Groundwater changes over short distances and with depth, so a nearby well says what the aquifer can hold, not what a well on this lot gives. Bacteria aren't shown: they depend on how each well is built and kept. Health Canada's Guidelines for Canadian Drinking Water Quality set the most a drinking water should hold: arsenic 0.010 mg/L, fluoride 1.5 mg/L, manganese 0.12 mg/L (and 0.02 mg/L for taste and for staining laundry and fixtures), uranium 0.02 mg/L, nitrate 10 mg/L as nitrogen (45 mg/L as nitrate) and lead 0.005 mg/L, with arsenic and lead kept as low as reasonably achievable. Our summary of Health Canada's summary table, read 2026-10-11.
Test your own well, for bacteria and these, at an accredited lab; your health authority can say which labs take samples from private wells. Health authority contacts.
Source: Environmental Monitoring Data System (EnMoDS) results, Province of BC (Open Government Licence – British Columbia); Health Canada's guidelines. Wells are those the Province links to this aquifer; a well with no link counts here when this is the only mapped aquifer under it. Wording by PlaceDossier.
Where it is
| Kind | Fractured crystalline bedrock |
|---|---|
| Geological unit | Coast Plutonic diorite; Pre-Jurassic Twin Island Group |
| Location, as described | Belcarra |
| Area | 1.8 km² |
| Water use | Household wells |
| Mapped | 2007 |
Bedrock: water moves through cracks in the rock, so two wells close together can find very different amounts. The province's page for this aquifer lists the studies behind it and its observation wells: GWELLS aquifer 68.
Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.
What this record doesn't cover
The province maps aquifers where wells and studies give enough to go on, mostly in settled valleys; most of BC isn't mapped, and a lot outside every outline can still have groundwater. Outlines are drawn from geology and well logs at the scale of the study, so an edge can be well off on the ground, and one aquifer can lie under another. Wells are linked to an aquifer by provincial staff from the driller's log: not every well inside an outline is linked, and well depths and yields are as the driller reported them, often from a short test.
These are mapped ratings and drillers' records, not a test of any one lot. Before you buy a property on a well, or plan to drill, ask a qualified hydrogeologist or a registered well driller what this aquifer gives where you are, and test the water.