PlaceDossier / BC places / Aquifers

Aquifer 664: Little Qualicum River

Aquifer 664 (Little Qualicum River) is an unconfined sand and gravel (small stream system) aquifer of 3.9 km² in the Nanaimo Regional District, mapped in 2023. The province rates its vulnerability to contamination from the surface high; its productivity and demand are not rated. 47 wells on record are linked to it; water-supply wells there are typically 11.3 m deep and tested at a median 94.6 L/min. It lies under Nanaimo, Electoral Area G (78%), Qualicum Beach (12%), Nanaimo, Electoral Area F (10%).

BC aquifer 664 · sand and gravel · 3.9 km² · Nanaimo

How the province rates it

Productivity not rated, vulnerability high, demand not rated.

RatingWhat it means
Productivity
how much water the aquifer gives up to wells, judged from well yields, the aquifer material and pumping tests
not ratedThe province hasn't rated this for this aquifer.
Vulnerability
how easily something spilled at the ground surface could reach the water, judged from what lies above the aquifer and how deep the water is
high (class A)Little natural protection (class A in the Province's aquifer classification guide): a shallow water table or sand and gravel above it lets surface water and spills soak down quickly.
Demand
how much the aquifer is used now, judged from the number and density of wells and what they're used for
not ratedThe province hasn't rated this for this aquifer.
Level of development Inferred
demand compared with productivity
unclearUnclear: the province hasn't rated both demand and productivity.

Ratings are the province's, set when the aquifer was mapped (2023) from wells, geology and local studies. Vulnerability is about the ground, not what's built on it: a well-protected aquifer under a busy area can still be at more risk than an exposed one in the bush.

Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.

The wells in it

47 wells on record are linked to this aquifer.

Wells linked47 (36 water-supply)
Water-supply well depthmedian 11.3 m; middle half 7.9 m to 12.5 m (35 wells)
Tested yieldmedian 94.6 L/min; middle half 39.7 L/min to 180 L/min (22 wells tested)
Water level below groundmedian 2.1 m when drilled (30 wells)
Drilled1950 to 2020
Well depth shallower than 90% of the 637 BC aquifers with at least 10 wells with a depth
131030100300 m Median 11.3 m from 35 wells
Tested yield higher than 80% of the 542 BC aquifers with at least 10 wells tested
1310301003001,0003,000 L/min Median 94.6 L/min from 22 wells

This aquifer's medianIts middle half of wellsAnother BC aquifer's median

Depths are how deep the driller finished the well; yields are the driller's test, often an hour or less, in litres per minute. A domestic well's yield is usually judged against the household's peak use; ask a driller what's enough for yours.

Is the water level falling?

1 provincial observation well still measured here.

Observation well 389water level stable or no clear trend over 2014 to 2023, as over the whole record since 2010; well 18 m deep

Observation wells are the Province's monitoring wells, their water level measured for years or decades. The trend is the Province's reading of one well's yearly levels: a decline of 3 to 10 cm a year that the record clearly shows is a moderate rate, 10 cm or more a large one, anything not clear is stable or no clear trend. It shows how the aquifer has behaved there, not what a well on this lot will give; confirm with a qualified hydrogeologist or registered well driller.

Source: Long-term Trends in Groundwater Levels in B.C., Environmental Reporting BC (Provincial Groundwater Observation Well Network), records to December 2023 (Open Government Licence – British Columbia). Wording by PlaceDossier.

What the water tested for

The median manganese was over Health Canada's limit at 1 of 1 wells sampled here.

1 well in this aquifer was sampled for the Province's records from 2011 to 2013, one of them the Province's observation well 389.

Typical well (median)Highest sampleSamples over the limitWells
Arsenic
limit 0.010 mg/L
0.000086 mg/L0.000111 mg/Lnone of 4 samples1
Fluoride
limit 1.5 mg/L
0.0265 mg/L0.028 mg/Lnone of 4 samples1
Manganese
limit 0.12 mg/L; 0.02 mg/L for taste and staining
1.05 mg/L1.14 mg/L4 of 4 samples, at 1 well
4 over the taste and staining level
1
Uranium
limit 0.02 mg/L
0.0000195 mg/L0.000025 mg/Lnone of 4 samples1
Nitrate (as nitrogen)
limit 10 mg/L
0.002 mg/L0.009 mg/Lnone of 4 samples1
Lead
limit 0.005 mg/L
0.0000075 mg/L0.00003 mg/Lnone of 4 samples1

These are samples of raw water, before any treatment, from wells in the Province's environmental monitoring records since 2000: its observation wells and groundwater surveys, water systems' wells and other drinking-water wells; wells at landfills, mines and permit holders' works are left out. A result below the lab's detection limit counts at that limit. Lead mostly comes from a well's pipes and fittings rather than the aquifer. Groundwater changes over short distances and with depth, so a nearby well says what the aquifer can hold, not what a well on this lot gives. Bacteria aren't shown: they depend on how each well is built and kept. Health Canada's Guidelines for Canadian Drinking Water Quality set the most a drinking water should hold: arsenic 0.010 mg/L, fluoride 1.5 mg/L, manganese 0.12 mg/L (and 0.02 mg/L for taste and for staining laundry and fixtures), uranium 0.02 mg/L, nitrate 10 mg/L as nitrogen (45 mg/L as nitrate) and lead 0.005 mg/L, with arsenic and lead kept as low as reasonably achievable. Our summary of Health Canada's summary table, read 2026-10-11.

Test your own well, for bacteria and these, at an accredited lab; your health authority can say which labs take samples from private wells. Health authority contacts.

Source: Environmental Monitoring Data System (EnMoDS) results, Province of BC (Open Government Licence – British Columbia); Health Canada's guidelines. Wells are those the Province links to this aquifer; a well with no link counts here when this is the only mapped aquifer under it. Wording by PlaceDossier.

Where it is

N 01 km

The aquifer's outline as the Province maps it. Zoom in to see the lots over it; tap one for its report.
Share

TextEmail

Text and Email open your messages or email app with this message, ready to edit.

KindUnconfined sand and gravel aquifer - small stream system
Geological unitSalish sediments
Location, as describedLittle Qualicum River valley and delta
Area3.9 km²
Water useSeveral uses (for example household wells, water systems, irrigation or industry)
Mapped2023

Unconfined: nothing tight lies over it, so rain and surface water soak straight down to it; the water table rises and falls with the seasons. The province's page for this aquifer lists the studies behind it and its observation wells: GWELLS aquifer 664.

Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.

What this record doesn't cover

The province maps aquifers where wells and studies give enough to go on, mostly in settled valleys; most of BC isn't mapped, and a lot outside every outline can still have groundwater. Outlines are drawn from geology and well logs at the scale of the study, so an edge can be well off on the ground, and one aquifer can lie under another. Wells are linked to an aquifer by provincial staff from the driller's log: not every well inside an outline is linked, and well depths and yields are as the driller reported them, often from a short test.

These are mapped ratings and drillers' records, not a test of any one lot. Before you buy a property on a well, or plan to drill, ask a qualified hydrogeologist or a registered well driller what this aquifer gives where you are, and test the water.