PlaceDossier / BC places / Aquifers
Aquifer 608: North Central Saanich
Aquifer 608 (North Central Saanich) is a fractured crystalline bedrock aquifer of 80 km² in the Capital Regional District, mapped in 2012. The province rates its productivity moderate, its vulnerability to contamination from the surface moderate, and the demand on it moderate. 1,424 wells on record are linked to it; water-supply wells there are typically 52.6 m deep and tested at a median 18.9 L/min. It lies under Central Saanich (43%), North Saanich (35%), Saanich (7%), Sidney (6%).
BC aquifer 608 · bedrock · 80 km² · Capital
How the province rates it
Productivity moderate, vulnerability moderate, demand moderate.
| Rating | What it means | |
|---|---|---|
| Productivity how much water the aquifer gives up to wells, judged from well yields, the aquifer material and pumping tests | moderate | Middling yields. The moderate band in the Province's aquifer classification guide is medium sand, or typical well yields of about 0.3 to 3 L/s (18 to 180 L/min). |
| Vulnerability how easily something spilled at the ground surface could reach the water, judged from what lies above the aquifer and how deep the water is | moderate (class B) | Some natural protection (class B), which can vary across the aquifer. |
| Demand how much the aquifer is used now, judged from the number and density of wells and what they're used for | moderate | Moderately used: about 4 to 20 domestic wells per km² where homes rely on private wells. |
| Level of development Inferred demand compared with productivity | Moderate (class II) | Read by us from the guide's table of demand against productivity; where it gives two classes the mapper chose with local knowledge. Heavy (I): new wells should be carefully assessed; moderate (II): given careful thought; light (III): more use is usually fine if the aquifer can supply it. |
Ratings are the province's, set when the aquifer was mapped (2012) from wells, geology and local studies. Vulnerability is about the ground, not what's built on it: a well-protected aquifer under a busy area can still be at more risk than an exposed one in the bush.
Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.
The wells in it
1,424 wells on record are linked to this aquifer.
| Wells linked | 1,424 (427 water-supply) |
|---|---|
| Water-supply well depth | median 52.6 m; middle half 30.5 m to 103 m (426 wells) |
| Tested yield | median 18.9 L/min; middle half 9.5 L/min to 37.9 L/min (414 wells tested) |
| Water level below ground | median 3.7 m when drilled (169 wells) |
| Flowing (artesian) wells | 59: water rose to or above the ground when drilled |
| Drilled | 1900 to 2018 |
This aquifer's medianIts middle half of wellsAnother BC aquifer's median
Depths are how deep the driller finished the well; yields are the driller's test, often an hour or less, in litres per minute. A domestic well's yield is usually judged against the household's peak use; ask a driller what's enough for yours.
Is the water level falling?
4 provincial observation wells still measured here.
| Observation well 240 | water level stable or no clear trend over 2014 to 2023, as over the whole record since 1981; water typically 5 m below ground in a well 152 m deep |
|---|---|
| Observation well 265 | water level stable or no clear trend over 2014 to 2023, as over the whole record since 1980; water typically 7 m below ground in a well 30 m deep |
| Observation well 338 | water level rising about 9.3 cm a year over 2014 to 2023; rising about 3.8 cm a year over 1998 to 2023; well 213 m deep |
| Observation well 343 | water level stable or no clear trend over 2014 to 2023, as over the whole record since 1998; well 152 m deep |
| Observation well 064 | no trend: no longer measured; water typically 3 m below ground in a well 162 m deep (records 1974 to 1998) |
| Observation well 065 | water level stable or no clear trend over 1975 to 2017; water typically 2 m below ground in a well 154 m deep (records 1975 to 2017) |
| Observation well 069 | no trend: no longer measured; water typically 7 m below ground in a well 167 m deep (records 1975 to 1998) |
| Observation well 212 | no trend: no longer measured; well 41 m deep (records 1977 to 2010) |
| Observation well 300 | no trend: no longer measured; well 67 m deep (records 1988 to 1998) |
| Observation well 333 | no trend: no longer measured; well 61 m deep |
| Observation well 334 | no trend: no longer measured; water typically 9 m below ground in a well 152 m deep |
Observation wells are the Province's monitoring wells, their water level measured for years or decades. The trend is the Province's reading of one well's yearly levels: a decline of 3 to 10 cm a year that the record clearly shows is a moderate rate, 10 cm or more a large one, anything not clear is stable or no clear trend. It shows how the aquifer has behaved there, not what a well on this lot will give; confirm with a qualified hydrogeologist or registered well driller.
Source: Long-term Trends in Groundwater Levels in B.C., Environmental Reporting BC (Provincial Groundwater Observation Well Network), records to December 2023 (Open Government Licence – British Columbia). Wording by PlaceDossier.
What the water tested for
The median manganese was over Health Canada's limit at 4 of 8 wells sampled here.
8 wells in this aquifer were sampled for the Province's records from 2000 to 2015, 8 of them the Province's observation wells (065, 066, 212, 240, 265, 333, 338, 343).
| Typical well (median) | Highest sample | Samples over the limit | Wells | |
|---|---|---|---|---|
| Arsenic limit 0.010 mg/L | 0.00071 mg/L | 0.0032 mg/L | none of 20 samples | 8 |
| Fluoride limit 1.5 mg/L | 0.07 mg/L | 0.52 mg/L | none of 21 samples | 8 |
| Manganese limit 0.12 mg/L; 0.02 mg/L for taste and staining | 0.103 mg/L | 0.431 mg/L | 12 of 21 samples, at 4 wells 17 over the taste and staining level | 8 |
| Uranium limit 0.02 mg/L | 0.00381 mg/L | 0.00799 mg/L | none of 16 samples | 7 |
| Nitrate (as nitrogen) limit 10 mg/L | 0.00275 mg/L | 0.054 mg/L | none of 16 samples | 6 |
| Lead limit 0.005 mg/L | 0.00005 mg/L | 0.00155 mg/L | none of 16 samples | 7 |
These are samples of raw water, before any treatment, from wells in the Province's environmental monitoring records since 2000: its observation wells and groundwater surveys, water systems' wells and other drinking-water wells; wells at landfills, mines and permit holders' works are left out. A result below the lab's detection limit counts at that limit. Lead mostly comes from a well's pipes and fittings rather than the aquifer. Groundwater changes over short distances and with depth, so a nearby well says what the aquifer can hold, not what a well on this lot gives. Bacteria aren't shown: they depend on how each well is built and kept. Health Canada's Guidelines for Canadian Drinking Water Quality set the most a drinking water should hold: arsenic 0.010 mg/L, fluoride 1.5 mg/L, manganese 0.12 mg/L (and 0.02 mg/L for taste and for staining laundry and fixtures), uranium 0.02 mg/L, nitrate 10 mg/L as nitrogen (45 mg/L as nitrate) and lead 0.005 mg/L, with arsenic and lead kept as low as reasonably achievable. Our summary of Health Canada's summary table, read 2026-10-11.
Test your own well, for bacteria and these, at an accredited lab; your health authority can say which labs take samples from private wells. Health authority contacts.
Source: Environmental Monitoring Data System (EnMoDS) results, Province of BC (Open Government Licence – British Columbia); Health Canada's guidelines. Wells are those the Province links to this aquifer; a well with no link counts here when this is the only mapped aquifer under it. Wording by PlaceDossier.
Where it is
| Kind | Fractured crystalline bedrock |
|---|---|
| Geological unit | Island Plutonic Suite |
| Location, as described | North Saanich to Elk Lake |
| Area | 80 km² |
| Water use | Several uses (for example household wells, water systems, irrigation or industry) |
| Water quality concerns | Isolated: concerns documented at a few wells |
| Mapped | 2012 |
Bedrock: water moves through cracks in the rock, so two wells close together can find very different amounts. The province's page for this aquifer lists the studies behind it and its observation wells: GWELLS aquifer 608.
Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.
What this record doesn't cover
The province maps aquifers where wells and studies give enough to go on, mostly in settled valleys; most of BC isn't mapped, and a lot outside every outline can still have groundwater. Outlines are drawn from geology and well logs at the scale of the study, so an edge can be well off on the ground, and one aquifer can lie under another. Wells are linked to an aquifer by provincial staff from the driller's log: not every well inside an outline is linked, and well depths and yields are as the driller reported them, often from a short test.
These are mapped ratings and drillers' records, not a test of any one lot. Before you buy a property on a well, or plan to drill, ask a qualified hydrogeologist or a registered well driller what this aquifer gives where you are, and test the water.