PlaceDossier / BC places / Aquifers

Aquifer 523: Cranbrook South, bedrock

Aquifer 523 (Cranbrook South, bedrock) is a fractured sedimentary rock aquifer of 29 km² in the East Kootenay Regional District, mapped in 2003. The province rates its productivity low, its vulnerability to contamination from the surface moderate, and the demand on it moderate. 240 wells on record are linked to it; water-supply wells there are typically 50.6 m deep and tested at a median 37.9 L/min. It lies under East Kootenay, Electoral Area C (91%), Cranbrook (9%).

BC aquifer 523 · bedrock · 29 km² · East Kootenay

How the province rates it

Productivity low, vulnerability moderate, demand moderate.

RatingWhat it means
Productivity
how much water the aquifer gives up to wells, judged from well yields, the aquifer material and pumping tests
lowWater comes slowly. The low band in the Province's aquifer classification guide is silt, fine sand or fractured bedrock, or typical well yields under about 0.3 L/s (18 L/min). A well may still supply a house, but it isn't assured.
Vulnerability
how easily something spilled at the ground surface could reach the water, judged from what lies above the aquifer and how deep the water is
moderate (class B)Some natural protection (class B), which can vary across the aquifer.
Demand
how much the aquifer is used now, judged from the number and density of wells and what they're used for
moderateModerately used: about 4 to 20 domestic wells per km² where homes rely on private wells.
Level of development Inferred
demand compared with productivity
Heavy or moderate (class I or II)Read by us from the guide's table of demand against productivity; where it gives two classes the mapper chose with local knowledge. Heavy (I): new wells should be carefully assessed; moderate (II): given careful thought; light (III): more use is usually fine if the aquifer can supply it.

Ratings are the province's, set when the aquifer was mapped (2003) from wells, geology and local studies. Vulnerability is about the ground, not what's built on it: a well-protected aquifer under a busy area can still be at more risk than an exposed one in the bush.

Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.

The wells in it

240 wells on record are linked to this aquifer.

Wells linked240 (121 water-supply)
Water-supply well depthmedian 50.6 m; middle half 42.7 m to 70.1 m (121 wells)
Tested yieldmedian 37.9 L/min; middle half 22.7 L/min to 56.8 L/min (113 wells tested)
Water level below groundmedian 14 m when drilled (99 wells)
Flowing (artesian) wells4: water rose to or above the ground when drilled
Drilled1950 to 1987
Well depth deeper than 62% of the 637 BC aquifers with at least 10 wells with a depth
131030100300 m Median 50.6 m from 121 wells
Tested yield lower than 54% of the 542 BC aquifers with at least 10 wells tested
1310301003001,0003,000 L/min Median 37.9 L/min from 113 wells

This aquifer's medianIts middle half of wellsAnother BC aquifer's median

Depths are how deep the driller finished the well; yields are the driller's test, often an hour or less, in litres per minute. A domestic well's yield is usually judged against the household's peak use; ask a driller what's enough for yours.

Is the water level falling?

1 provincial observation well still measured here.

Observation well 291water level falling about 64 cm a year (large rate) over 2014 to 2023; stable or no clear trend over 1989 to 2023; water typically 12 m below ground in a well 76 m deep

Observation wells are the Province's monitoring wells, their water level measured for years or decades. The trend is the Province's reading of one well's yearly levels: a decline of 3 to 10 cm a year that the record clearly shows is a moderate rate, 10 cm or more a large one, anything not clear is stable or no clear trend. It shows how the aquifer has behaved there, not what a well on this lot will give; confirm with a qualified hydrogeologist or registered well driller.

Source: Long-term Trends in Groundwater Levels in B.C., Environmental Reporting BC (Provincial Groundwater Observation Well Network), records to December 2023 (Open Government Licence – British Columbia). Wording by PlaceDossier.

What the water tested for

The median nitrate (as nitrogen) was over Health Canada's limit at 1 of 1 wells sampled here.

1 well in this aquifer was sampled for the Province's records from 2009 to 2017, one of them the Province's observation well 291.

Typical well (median)Highest sampleSamples over the limitWells
Arsenic
limit 0.010 mg/L
0.00054 mg/L0.00073 mg/Lnone of 3 samples1
Fluoride
limit 1.5 mg/L
0.18 mg/L0.25 mg/Lnone of 3 samples1
Manganese
limit 0.12 mg/L; 0.02 mg/L for taste and staining
0.00191 mg/L0.00207 mg/Lnone of 3 samples1
Uranium
limit 0.02 mg/L
0.00677 mg/L0.00715 mg/Lnone of 3 samples1
Nitrate (as nitrogen)
limit 10 mg/L
10.4 mg/L17.8 mg/L2 of 3 samples, at 1 well1
Lead
limit 0.005 mg/L
0.000093 mg/L0.000605 mg/Lnone of 3 samples1

These are samples of raw water, before any treatment, from wells in the Province's environmental monitoring records since 2000: its observation wells and groundwater surveys, water systems' wells and other drinking-water wells; wells at landfills, mines and permit holders' works are left out. A result below the lab's detection limit counts at that limit. Lead mostly comes from a well's pipes and fittings rather than the aquifer. Groundwater changes over short distances and with depth, so a nearby well says what the aquifer can hold, not what a well on this lot gives. Bacteria aren't shown: they depend on how each well is built and kept. Health Canada's Guidelines for Canadian Drinking Water Quality set the most a drinking water should hold: arsenic 0.010 mg/L, fluoride 1.5 mg/L, manganese 0.12 mg/L (and 0.02 mg/L for taste and for staining laundry and fixtures), uranium 0.02 mg/L, nitrate 10 mg/L as nitrogen (45 mg/L as nitrate) and lead 0.005 mg/L, with arsenic and lead kept as low as reasonably achievable. Our summary of Health Canada's summary table, read 2026-10-11.

Test your own well, for bacteria and these, at an accredited lab; your health authority can say which labs take samples from private wells. Health authority contacts.

Source: Environmental Monitoring Data System (EnMoDS) results, Province of BC (Open Government Licence – British Columbia); Health Canada's guidelines. Wells are those the Province links to this aquifer; a well with no link counts here when this is the only mapped aquifer under it. Wording by PlaceDossier.

Where it is

N 02 km

The aquifer's outline as the Province maps it. Zoom in to see the lots over it; tap one for its report.
Share

TextEmail

Text and Email open your messages or email app with this message, ready to edit.

KindFractured sedimentary rock
Location, as describedCranbrook South, bedrock
Area29 km²
Water useHousehold wells
Water quality concernsNone documented
Mapped2003

Bedrock: water moves through cracks in the rock, so two wells close together can find very different amounts. The province's page for this aquifer lists the studies behind it and its observation wells: GWELLS aquifer 523.

Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.

What this record doesn't cover

The province maps aquifers where wells and studies give enough to go on, mostly in settled valleys; most of BC isn't mapped, and a lot outside every outline can still have groundwater. Outlines are drawn from geology and well logs at the scale of the study, so an edge can be well off on the ground, and one aquifer can lie under another. Wells are linked to an aquifer by provincial staff from the driller's log: not every well inside an outline is linked, and well depths and yields are as the driller reported them, often from a short test.

These are mapped ratings and drillers' records, not a test of any one lot. Before you buy a property on a well, or plan to drill, ask a qualified hydrogeologist or a registered well driller what this aquifer gives where you are, and test the water.