PlaceDossier / BC places / Aquifers
Aquifer 21: Sumas Prairie
Aquifer 21 (Sumas Prairie) is an unconfined sand and gravel (large river system) aquifer of 98 km² in the Fraser Valley Regional District, mapped in 2012. The province rates its productivity moderate, its vulnerability to contamination from the surface moderate, and the demand on it moderate. 202 wells on record are linked to it; water-supply wells there are typically 6.1 m deep and tested at a median 227 L/min. It lies under Abbotsford.
BC aquifer 21 · sand and gravel · 98 km² · Fraser Valley
How the province rates it
Productivity moderate, vulnerability moderate, demand moderate.
| Rating | What it means | |
|---|---|---|
| Productivity how much water the aquifer gives up to wells, judged from well yields, the aquifer material and pumping tests | moderate | Middling yields. The moderate band in the Province's aquifer classification guide is medium sand, or typical well yields of about 0.3 to 3 L/s (18 to 180 L/min). |
| Vulnerability how easily something spilled at the ground surface could reach the water, judged from what lies above the aquifer and how deep the water is | moderate (class B) | Some natural protection (class B), which can vary across the aquifer. |
| Demand how much the aquifer is used now, judged from the number and density of wells and what they're used for | moderate | Moderately used: about 4 to 20 domestic wells per km² where homes rely on private wells. |
| Level of development Inferred demand compared with productivity | Moderate (class II) | Read by us from the guide's table of demand against productivity; where it gives two classes the mapper chose with local knowledge. Heavy (I): new wells should be carefully assessed; moderate (II): given careful thought; light (III): more use is usually fine if the aquifer can supply it. |
Ratings are the province's, set when the aquifer was mapped (2012) from wells, geology and local studies. Vulnerability is about the ground, not what's built on it: a well-protected aquifer under a busy area can still be at more risk than an exposed one in the bush.
Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.
The wells in it
202 wells on record are linked to this aquifer.
| Wells linked | 202 (147 water-supply) |
|---|---|
| Water-supply well depth | median 6.1 m; middle half 4.6 m to 18.3 m (144 wells) |
| Tested yield | median 227 L/min; middle half 53.9 L/min to 544 L/min (26 wells tested) |
| Water level below ground | median 2.1 m when drilled (55 wells) |
| Flowing (artesian) wells | 1: water rose to or above the ground when drilled |
| Drilled | 1945 to 2016 |
This aquifer's medianIts middle half of wellsAnother BC aquifer's median
Depths are how deep the driller finished the well; yields are the driller's test, often an hour or less, in litres per minute. A domestic well's yield is usually judged against the household's peak use; ask a driller what's enough for yours.
What the water tested for
The median was over Health Canada's limit at some of the wells sampled here: arsenic at 1 of 5, manganese at 1 of 5, nitrate (as nitrogen) at 1 of 5.
5 wells in this aquifer were sampled for the Province's records from 2000 to 2024, one of them the Province's observation well 457.
| Typical well (median) | Highest sample | Samples over the limit | Wells | |
|---|---|---|---|---|
| Arsenic limit 0.010 mg/L | 0.00165 mg/L | 0.0147 mg/L | 4 of 42 samples, at 1 well | 5 |
| Fluoride limit 1.5 mg/L | 0.04 mg/L | 0.177 mg/L | none of 21 samples | 5 |
| Manganese limit 0.12 mg/L; 0.02 mg/L for taste and staining | 0.00183 mg/L | 0.516 mg/L | 4 of 60 samples, at 1 well 8 over the taste and staining level | 5 |
| Uranium limit 0.02 mg/L | 0.0000986 mg/L | 0.00127 mg/L | none of 42 samples | 5 |
| Nitrate (as nitrogen) limit 10 mg/L | 2.83 mg/L | 11.9 mg/L | 12 of 53 samples, at 1 well | 5 |
| Lead limit 0.005 mg/L | 0.000124 mg/L | 0.0167 mg/L | 1 of 42 samples, at 1 well | 5 |
These are samples of raw water, before any treatment, from wells in the Province's environmental monitoring records since 2000: its observation wells and groundwater surveys, water systems' wells and other drinking-water wells; wells at landfills, mines and permit holders' works are left out. A result below the lab's detection limit counts at that limit. Lead mostly comes from a well's pipes and fittings rather than the aquifer. Groundwater changes over short distances and with depth, so a nearby well says what the aquifer can hold, not what a well on this lot gives. Bacteria aren't shown: they depend on how each well is built and kept. Health Canada's Guidelines for Canadian Drinking Water Quality set the most a drinking water should hold: arsenic 0.010 mg/L, fluoride 1.5 mg/L, manganese 0.12 mg/L (and 0.02 mg/L for taste and for staining laundry and fixtures), uranium 0.02 mg/L, nitrate 10 mg/L as nitrogen (45 mg/L as nitrate) and lead 0.005 mg/L, with arsenic and lead kept as low as reasonably achievable. Our summary of Health Canada's summary table, read 2026-10-11.
Test your own well, for bacteria and these, at an accredited lab; your health authority can say which labs take samples from private wells. Health authority contacts.
Source: Environmental Monitoring Data System (EnMoDS) results, Province of BC (Open Government Licence – British Columbia); Health Canada's guidelines. Wells are those the Province links to this aquifer; a well with no link counts here when this is the only mapped aquifer under it. Wording by PlaceDossier.
Where it is
| Kind | Unconfined sand and gravel - large river system |
|---|---|
| Geological unit | Salish Sediments; Fraser River Sediments |
| Location, as described | Sumas Prairie |
| Area | 98 km² |
| Water use | Several uses (for example household wells, water systems, irrigation or industry) |
| Water quality concerns | None documented |
| Mapped | 2012 |
Unconfined: nothing tight lies over it, so rain and surface water soak straight down to it; the water table rises and falls with the seasons. The province's page for this aquifer lists the studies behind it and its observation wells: GWELLS aquifer 21.
Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.
What this record doesn't cover
The province maps aquifers where wells and studies give enough to go on, mostly in settled valleys; most of BC isn't mapped, and a lot outside every outline can still have groundwater. Outlines are drawn from geology and well logs at the scale of the study, so an edge can be well off on the ground, and one aquifer can lie under another. Wells are linked to an aquifer by provincial staff from the driller's log: not every well inside an outline is linked, and well depths and yields are as the driller reported them, often from a short test.
These are mapped ratings and drillers' records, not a test of any one lot. Before you buy a property on a well, or plan to drill, ask a qualified hydrogeologist or a registered well driller what this aquifer gives where you are, and test the water.