PlaceDossier / BC places / Aquifers
Aquifer 1297: Abbotsford Shallow West
Aquifer 1297 (Abbotsford Shallow West) is an unconfined sand and gravel (late glacial outwash) aquifer of 29 km² in the Metro Vancouver Regional District, mapped in 2025. The province rates its productivity high and its vulnerability to contamination from the surface high; its demand is not rated. 229 wells on record are linked to it; water-supply wells there are typically 16.3 m deep and tested at a median 75.7 L/min. It lies under Langley (district municipality) (58%), Abbotsford (41%).
BC aquifer 1297 · sand and gravel · 29 km² · Metro Vancouver
How the province rates it
Productivity high, vulnerability high, demand not rated.
| Rating | What it means | |
|---|---|---|
| Productivity how much water the aquifer gives up to wells, judged from well yields, the aquifer material and pumping tests | high | Wells here tend to yield well. The Province's aquifer classification guide puts high productivity at coarse sand and gravel, or typical well yields over about 3 L/s (180 L/min). |
| Vulnerability how easily something spilled at the ground surface could reach the water, judged from what lies above the aquifer and how deep the water is | high (class A) | Little natural protection (class A in the Province's aquifer classification guide): a shallow water table or sand and gravel above it lets surface water and spills soak down quickly. |
| Demand how much the aquifer is used now, judged from the number and density of wells and what they're used for | not rated | The province hasn't rated this for this aquifer. |
| Level of development Inferred demand compared with productivity | unclear | Unclear: the province hasn't rated both demand and productivity. |
Ratings are the province's, set when the aquifer was mapped (2025) from wells, geology and local studies. Vulnerability is about the ground, not what's built on it: a well-protected aquifer under a busy area can still be at more risk than an exposed one in the bush.
Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.
The wells in it
229 wells on record are linked to this aquifer.
| Wells linked | 229 (118 water-supply) |
|---|---|
| Water-supply well depth | median 16.3 m; middle half 7.7 m to 33.2 m (110 wells) |
| Tested yield | median 75.7 L/min; middle half 37.9 L/min to 151 L/min (72 wells tested) |
| Water level below ground | median 5.9 m when drilled (80 wells) |
| Flowing (artesian) wells | 1: water rose to or above the ground when drilled |
| Drilled | 1938 to 2023 |
This aquifer's medianIts middle half of wellsAnother BC aquifer's median
Depths are how deep the driller finished the well; yields are the driller's test, often an hour or less, in litres per minute. A domestic well's yield is usually judged against the household's peak use; ask a driller what's enough for yours.
What the water tested for
No well sampled here had a median over Health Canada's limits, though some single samples were.
1 well in this aquifer was sampled for the Province's records from 2003 to 2016, one of them the Province's observation well 301.
| Typical well (median) | Highest sample | Samples over the limit | Wells | |
|---|---|---|---|---|
| Arsenic limit 0.010 mg/L | 0.0047 mg/L | 0.0076 mg/L | none of 20 samples | 1 |
| Fluoride limit 1.5 mg/L | 0.07 mg/L | 0.1 mg/L | none of 19 samples | 1 |
| Manganese limit 0.12 mg/L; 0.02 mg/L for taste and staining | 0.0759 mg/L | 0.303 mg/L | 7 of 20 samples, at 1 well 20 over the taste and staining level | 1 |
| Uranium limit 0.02 mg/L | 0.0000525 mg/L | 0.000096 mg/L | none of 20 samples | 1 |
| Nitrate (as nitrogen) limit 10 mg/L | 0.652 mg/L | 2.31 mg/L | none of 19 samples | 1 |
| Lead limit 0.005 mg/L | 0.0000385 mg/L | 0.00053 mg/L | none of 20 samples | 1 |
These are samples of raw water, before any treatment, from wells in the Province's environmental monitoring records since 2000: its observation wells and groundwater surveys, water systems' wells and other drinking-water wells; wells at landfills, mines and permit holders' works are left out. A result below the lab's detection limit counts at that limit. Lead mostly comes from a well's pipes and fittings rather than the aquifer. Groundwater changes over short distances and with depth, so a nearby well says what the aquifer can hold, not what a well on this lot gives. Bacteria aren't shown: they depend on how each well is built and kept. Health Canada's Guidelines for Canadian Drinking Water Quality set the most a drinking water should hold: arsenic 0.010 mg/L, fluoride 1.5 mg/L, manganese 0.12 mg/L (and 0.02 mg/L for taste and for staining laundry and fixtures), uranium 0.02 mg/L, nitrate 10 mg/L as nitrogen (45 mg/L as nitrate) and lead 0.005 mg/L, with arsenic and lead kept as low as reasonably achievable. Our summary of Health Canada's summary table, read 2026-10-11.
Test your own well, for bacteria and these, at an accredited lab; your health authority can say which labs take samples from private wells. Health authority contacts.
Source: Environmental Monitoring Data System (EnMoDS) results, Province of BC (Open Government Licence – British Columbia); Health Canada's guidelines. Wells are those the Province links to this aquifer; a well with no link counts here when this is the only mapped aquifer under it. Wording by PlaceDossier.
Where it is
| Kind | Unconfined sand and gravel - late glacial outwash |
|---|---|
| Geological unit | Sumas glaciofluvial outwash and channel fill deposits |
| Location, as described | Langley Uplands |
| Area | 29 km² |
| Water quality concerns | Regional: concerns documented across much of the aquifer |
| Mapped | 2025 |
Unconfined: nothing tight lies over it, so rain and surface water soak straight down to it; the water table rises and falls with the seasons. The province's page for this aquifer lists the studies behind it and its observation wells: GWELLS aquifer 1297.
Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.
What this record doesn't cover
The province maps aquifers where wells and studies give enough to go on, mostly in settled valleys; most of BC isn't mapped, and a lot outside every outline can still have groundwater. Outlines are drawn from geology and well logs at the scale of the study, so an edge can be well off on the ground, and one aquifer can lie under another. Wells are linked to an aquifer by provincial staff from the driller's log: not every well inside an outline is linked, and well depths and yields are as the driller reported them, often from a short test.
These are mapped ratings and drillers' records, not a test of any one lot. Before you buy a property on a well, or plan to drill, ask a qualified hydrogeologist or a registered well driller what this aquifer gives where you are, and test the water.