PlaceDossier / BC places / Aquifers

Aquifer 1250: Morningstar Creek to Grodon Creek

Aquifer 1250 (Morningstar Creek to Grodon Creek) is a confined sand and gravel (glacio-marine) aquifer of 15 km² in the Nanaimo Regional District, mapped in 2023. The province rates its productivity moderate and its vulnerability to contamination from the surface low; its demand is not rated. 77 wells on record are linked to it; water-supply wells there are typically 47.9 m deep and tested at a median 37.9 L/min. It lies under Qualicum Beach (45%), Nanaimo, Electoral Area G (44%), Nanaimo, Electoral Area F (11%).

BC aquifer 1250 · sand and gravel · 15 km² · Nanaimo

How the province rates it

Productivity moderate, vulnerability low, demand not rated.

RatingWhat it means
Productivity
how much water the aquifer gives up to wells, judged from well yields, the aquifer material and pumping tests
moderateMiddling yields. The moderate band in the Province's aquifer classification guide is medium sand, or typical well yields of about 0.3 to 3 L/s (18 to 180 L/min).
Vulnerability
how easily something spilled at the ground surface could reach the water, judged from what lies above the aquifer and how deep the water is
low (class C)Better protected (class C), usually by clay or silt above it or deep water. Not immune: a gap in the cover or a badly sealed well can still let contaminants in.
Demand
how much the aquifer is used now, judged from the number and density of wells and what they're used for
not ratedThe province hasn't rated this for this aquifer.
Level of development Inferred
demand compared with productivity
unclearUnclear: the province hasn't rated both demand and productivity.

Ratings are the province's, set when the aquifer was mapped (2023) from wells, geology and local studies. Vulnerability is about the ground, not what's built on it: a well-protected aquifer under a busy area can still be at more risk than an exposed one in the bush.

Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.

The wells in it

77 wells on record are linked to this aquifer.

Wells linked77 (61 water-supply)
Water-supply well depthmedian 47.9 m; middle half 40.8 m to 53.3 m (61 wells)
Tested yieldmedian 37.9 L/min; middle half 18.9 L/min to 85.2 L/min (59 wells tested)
Water level below groundmedian 24.4 m when drilled (54 wells)
Drilled1949 to 2018
Well depth deeper than 57% of the 637 BC aquifers with at least 10 wells with a depth
131030100300 m Median 47.9 m from 61 wells
Tested yield lower than 54% of the 542 BC aquifers with at least 10 wells tested
1310301003001,0003,000 L/min Median 37.9 L/min from 59 wells

This aquifer's medianIts middle half of wellsAnother BC aquifer's median

Depths are how deep the driller finished the well; yields are the driller's test, often an hour or less, in litres per minute. A domestic well's yield is usually judged against the household's peak use; ask a driller what's enough for yours.

Is the water level falling?

4 provincial observation wells still measured here.

Observation well 303water level rising about 22 cm a year over 2014 to 2023; stable or no clear trend over 1988 to 2023; water typically 18 m below ground in a well 49 m deep
Observation well 321water level rising about 46 cm a year over 2014 to 2023; stable or no clear trend over 1994 to 2023; water typically 6 m below ground in a well 42 m deep
Observation well 424water level stable or no clear trend over 2014 to 2023, as over the whole record since 2013; water typically 21 m below ground in a well 41 m deep
Observation well 433water level rising about 28 cm a year over 2014 to 2023, as over the whole record since 2013; water typically 40 m below ground in a well 94 m deep

Observation wells are the Province's monitoring wells, their water level measured for years or decades. The trend is the Province's reading of one well's yearly levels: a decline of 3 to 10 cm a year that the record clearly shows is a moderate rate, 10 cm or more a large one, anything not clear is stable or no clear trend. It shows how the aquifer has behaved there, not what a well on this lot will give; confirm with a qualified hydrogeologist or registered well driller.

Source: Long-term Trends in Groundwater Levels in B.C., Environmental Reporting BC (Provincial Groundwater Observation Well Network), records to December 2023 (Open Government Licence – British Columbia). Wording by PlaceDossier.

What the water tested for

The median was over Health Canada's limit at some of the wells sampled here: arsenic at 1 of 4, manganese at 2 of 4.

4 wells in this aquifer were sampled for the Province's records from 2002 to 2016, 4 of them the Province's observation wells (303, 321, 424, 433).

Typical well (median)Highest sampleSamples over the limitWells
Arsenic
limit 0.010 mg/L
0.00164 mg/L0.0177 mg/L1 of 10 samples, at 1 well4
Fluoride
limit 1.5 mg/L
0.1 mg/L0.14 mg/Lnone of 9 samples4
Manganese
limit 0.12 mg/L; 0.02 mg/L for taste and staining
0.0908 mg/L0.175 mg/L7 of 10 samples, at 2 wells
8 over the taste and staining level
4
Uranium
limit 0.02 mg/L
0.000008 mg/L0.000154 mg/Lnone of 9 samples4
Nitrate (as nitrogen)
limit 10 mg/L
0.0085 mg/L0.024 mg/Lnone of 9 samples4
Lead
limit 0.005 mg/L
0.000035 mg/L0.00376 mg/Lnone of 9 samples4

These are samples of raw water, before any treatment, from wells in the Province's environmental monitoring records since 2000: its observation wells and groundwater surveys, water systems' wells and other drinking-water wells; wells at landfills, mines and permit holders' works are left out. A result below the lab's detection limit counts at that limit. Lead mostly comes from a well's pipes and fittings rather than the aquifer. Groundwater changes over short distances and with depth, so a nearby well says what the aquifer can hold, not what a well on this lot gives. Bacteria aren't shown: they depend on how each well is built and kept. Health Canada's Guidelines for Canadian Drinking Water Quality set the most a drinking water should hold: arsenic 0.010 mg/L, fluoride 1.5 mg/L, manganese 0.12 mg/L (and 0.02 mg/L for taste and for staining laundry and fixtures), uranium 0.02 mg/L, nitrate 10 mg/L as nitrogen (45 mg/L as nitrate) and lead 0.005 mg/L, with arsenic and lead kept as low as reasonably achievable. Our summary of Health Canada's summary table, read 2026-10-11.

Test your own well, for bacteria and these, at an accredited lab; your health authority can say which labs take samples from private wells. Health authority contacts.

Source: Environmental Monitoring Data System (EnMoDS) results, Province of BC (Open Government Licence – British Columbia); Health Canada's guidelines. Wells are those the Province links to this aquifer; a well with no link counts here when this is the only mapped aquifer under it. Wording by PlaceDossier.

Where it is

N 02 km

The aquifer's outline as the Province maps it. Zoom in to see the lots over it; tap one for its report.
Share

TextEmail

Text and Email open your messages or email app with this message, ready to edit.

KindConfined sand and gravel - glacio-marine
Geological unitCowichan Head - Dashwood Sediments
Location, as describedMorningstar Creek to Grodon Creek
Area15 km²
Mapped2023

Confined: a layer of clay, silt or till lies over it, which slows water (and spills) from the surface; wells reach it through that layer. The province's page for this aquifer lists the studies behind it and its observation wells: GWELLS aquifer 1250.

Sources: Ground Water Aquifers, Water Protection and Sustainability Branch, Province of BC and Groundwater Wells (GWELLS), Province of BC, as published on October 1, 2026 (Open Government Licence – British Columbia); ratings explained after Berardinucci and Ronneseth (2002), Guide to Using the BC Aquifer Classification Maps for the Protection and Management of Groundwater, BC Ministry of Water, Land and Air Protection. Summaries by PlaceDossier.

What this record doesn't cover

The province maps aquifers where wells and studies give enough to go on, mostly in settled valleys; most of BC isn't mapped, and a lot outside every outline can still have groundwater. Outlines are drawn from geology and well logs at the scale of the study, so an edge can be well off on the ground, and one aquifer can lie under another. Wells are linked to an aquifer by provincial staff from the driller's log: not every well inside an outline is linked, and well depths and yields are as the driller reported them, often from a short test.

These are mapped ratings and drillers' records, not a test of any one lot. Before you buy a property on a well, or plan to drill, ask a qualified hydrogeologist or a registered well driller what this aquifer gives where you are, and test the water.